source: trunk

Revision Log Mode:


Legend:

Added
Modified
Copied or renamed
Diff Rev Age Author Log Message
(edit) @1769   5 weeks stefanct linux_spi: Stop messing up the units of SPI speed. 'speed' is stored in …
(edit) @1768   5 weeks stefanct linux_spi: Fix conversion from kHz to Hz. A kilohertz is exactly 1000 …
(edit) @1767   5 weeks stefanct Add support for Intel 82574L to nicintel_spi.c. Signed-off-by: Bill Paul …
(edit) @1766   5 weeks stefanct Add board enable for ASUS A7V8X-MX. Use the same trick as for the MX-SE …
(edit) @1765   7 weeks hailfinger Clean up physmap, fix unaligned mapping problems Convert all physmaps in …
(edit) @1764   5 months stefanct Add board enable for ASUS P5LD2-VM DH. Tested on real hardware by …
(edit) @1763   6 months stefanct Ensure DMI strings used in dmi_compare() are not NULL. Previously the …
(edit) @1762   6 months stefanct Add board enable for abit BF6. Because the board does not have any PCI …
(edit) @1761   6 months stefanct Refactor Intel Chipset Enables. - Combine enable_flash_ich_4e() and …
(edit) @1760   6 months stefanct programmer_delay: filter 0 usec delays. We use 0 as delay value for some …
(edit) @1759   6 months stefanct serial: use internal_delay() for timeouts. Using programmer_delay() for …
(edit) @1758   6 months stefanct Refine support for SST25VF family. - Reorder some models and refine …
(edit) @1757   7 months stefanct rayer_spi: Fix Xilinx DLC-5 cable. Pin 6 on LPT controls a pulldown on …
(edit) @1756   7 months stefanct rayer_spi: Add pinout for Wiggler LPT. Signed-off-by: Maksim Kuleshov …
(edit) @1755   7 months stefanct rayer_spi: Add pinout for Atmel STK200/300. Signed-off-by: Maksim …
(edit) @1754   7 months stefanct rayer_spi: Add pinout for Altera ByteBlasterMV. There is a ByteBlasterII …
(edit) @1753   7 months stefanct rayer_spi: Improve support for different pinouts. Create a list of …
(edit) @1751   7 months stefanct layout: Verify layout entries before building a new image using them. …
(edit) @1750   7 months stefanct sbxxx: Set SPI clock to 16.5 MHz and disable fast reads. Do not rely on …
(edit) @1749   7 months stefanct layout: Add a method to cleanup layout data structures. Add …
(edit) @1748   7 months stefanct Enable fwh_idsel parameter for C-ICH and ICH2/3/4/5 chipsets. Register …
(edit) @1747   7 months stefanct Use ich_generation parameter in enable functions prior to ICH7. Follow …
(edit) @1746   7 months stefanct Introduce enable_flash_ich_fwh_decode(). ICH2 (and C-ICH)/3/4/5 also have …
(edit) @1745   7 months stefanct Remove exit call and mayfail parameter from physmap_common(). The only …
(edit) @1744   7 months stefanct Remove exit call from sys_physmap_*. All callers are prepared to handle …
(edit) @1743   7 months stefanct Add debug output to programmer_map_flash_region(). While we don't expect …
(edit) @1742   7 months stefanct BSD refinements. Make it easier to compile flashrom under NetBSD and …
(edit) @1741   7 months stefanct sbxxx: Add detection for the remaining AMD chipset families. Also, …
(edit) @1740   7 months stefanct Makefile: Warn if user tries to compile for libpayload w/o crossgcc. …
(edit) @1739   7 months stefanct Fix ROM decoding on VIA VT82C596 and VT82C686A/B. These support an …
(edit) @1738   7 months stefanct Enable sector erase function for selected ST M50 chips. Affected chips: …
(edit) @1737   7 months stefanct Add support for ST M50LPW080. Signed-off-by: Stefan Tauner …
(edit) @1736   7 months stefanct Cleanup ST M50 driver. There are two locking strategies used by this …
(edit) @1735   7 months stefanct Add an internal DMI decoder. Previously we had to rely on dmidecode to …
(edit) @1734   7 months stefanct DOS refinements. This allows to use the DOS library trees stored in a …
(edit) @1733   7 months stefanct Add board enable for Bcom WinNET P680. This patch replaces Alex Mauer's …
(edit) @1732   8 months stefanct layout: Rename romlayout_t to romentry_t. The type describes one entry of …
(edit) @1731   8 months stefanct layout: Rename romimages to num_rom_entries. Since we are planning to …
(edit) @1730   8 months stefanct libpayload: Remove file I/O in flashrom.c. read_buf_from_file() and …
(edit) @1729   8 months stefanct Add now auto-generated manpage to svn:ignore. I had to touch svn …
(edit) @1728   8 months stefanct Automatically add version and date to the manpage. To avoid funny effects …
(edit) @1727   8 months stefanct Improve getrevision.sh. - remove bashism. - simplify some git-related …
(edit) @1726   8 months stefanct libpayload: By default build libflashrom.a instead of flashrom. flashrom …
(edit) @1725   8 months stefanct Add support for AT45CS1282. This one is even more strange than the AT45DB …
(edit) @1724   8 months stefanct Add support for AT45DB321C. It seems like this model is one-of-a-kind... …
(edit) @1723   8 months stefanct Add support for Atmel AT45DB* chips. Signed-off-by: Aidan Thornton …
(edit) @1722   8 months stefanct Add support for Fujitsu MBM29LV160BE/TE. Signed-off-by: Stefan Tauner …
(edit) @1721   8 months stefanct Makefile: Explain process of handling CONFIG_* variables. Signed-off-by: …
(edit) @1720   8 months stefanct IT87: Add ability to select between chips on GIGABYTE DualBIOS boards. …
(edit) @1719   8 months stefanct Get rid of sp_die(). - Add return values to sp_flush_stream(), …
(edit) @1718   8 months stefanct Add additional error handling to pcidev_readbar() callers. This is mostly …
(edit) @1717   8 months stefanct Introduce serialport_config(). This allows to easily reconfigure a serial …
(edit) @1716   8 months stefanct getrevision.sh: Make sure we don't get translated output. (And explicitly …
(edit) @1715   8 months stefanct Allow physmap_common() to round address ranges to page boundaries. …
(edit) @1714   8 months stefanct Automatically unmap physmap()s. Similarly to the previous PCI self-clean …
(edit) @1713   8 months stefanct Add getrevision.sh utility script. This allows to retrieve various data …
(edit) @1710   8 months stefanct Increase flashrom release number to 0.9.7. Signed-off-by: Stefan Tauner …
(edit) @1709   8 months stefanct Add a bunch of new/tested stuff and various small changes 19. Tested …
(edit) @1708   8 months hailfinger An unused programmer parameter is a sign that the user wanted to either do …
(edit) @1707   8 months stefanct Fix verification operation. I broke this in r1702 where I enabled …
(edit) @1706   8 months stefanct Detect AMD Yangtze (found in Kabini and Tamesh). The PCI ID of the LPC …
(edit) @1705   9 months stefanct dediprog: Fix crash if usb_open() fails. Signed-off-by: David Woodhouse …
(edit) @1704   9 months stefanct sbxxx: Handle active IMCs in AMD chipsets. Detect and temporarily disable …
(edit) @1703   9 months stefanct Rename Numonyx and ST (SGS/Thomson) chips to Micron. Micron acquired …
(edit) @1702   9 months stefanct Add a bunch of new/tested stuff and various small changes 18. Tested …
(edit) @1701   9 months stefanct uintptr_t-ify map_flash_region functions. unsigned long is not the right …
(edit) @1700   9 months stefanct print.c: Fix multiline support. - Use the reentrant tokenizer version …
(edit) @1699   9 months stefanct Differentiate ultimate error messages depending on programmer used. With …
(edit) @1698   9 months stefanct Use uintptr_t for chipaddr instead of unsigned long. Signed-off-by: …
(edit) @1697   9 months stefanct Various cross-platform fixes. Improve compilation with libpayload …
(edit) @1696   9 months stefanct Add support for AMD Geode's MSR on OpenBSD. Previously the default …
(edit) @1695   9 months stefanct Fix hwaccess (again). I completely forgot about NetBSD in r1638 which was …
(edit) @1694   9 months stefanct print_wiki: Fixes, explanation re. flash chips, links to footnotes. - …
(edit) @1693   10 months stefanct Add support for remaining Numonyx (Micron) N25Q chips. Add... - …
(edit) @1692   10 months stefanct Add support for Spansion S25FL...S chips. Add... - S25FL128S - …
(edit) @1691   10 months stefanct Add support for Spansion S25FL2 chips. Add... - S25FL204K - S25FL208K …
(edit) @1690   10 months stefanct Add support for Micron/Numonyx?/ST M25PX80. Also, refine status register …
(edit) @1689   10 months stefanct Add support for AMIC A25LQ16 and A25LQ64. Also, refine unlocking of …
(edit) @1688   10 months stefanct Add support for more Eon EN25QH chips. Add... - EN25QH64 - EN25QH128 - …
(edit) @1687   10 months stefanct Add support for Eon EN25S series. Add... - EN25S10 - EN25S20 - EN25S40 …
(edit) @1686   10 months stefanct Add support for Numonyx M45PE series. Add... - M45PE10 - M45PE20 - …
(edit) @1685   10 months stefanct Add support for some GigaDevice? GD25* chips. Add... - GigaDevice? GD25T80 …
(edit) @1684   10 months stefanct Add support for all Sanyo LE25FW chips. Add... - Sanyo LE25FW403A - …
(edit) @1683   10 months stefanct Add support for Nantronics N25 series. Add... - N25S10 - N25S20 - …
(edit) @1682   10 months stefanct Introduce spi_block_erase_db(). Used for page erase on some chips (e.g. …
(edit) @1681   10 months stefanct Introduce additional SPI status register helpers. - …
(edit) @1680   10 months stefanct Warn if we skipped all blocks while writing. Quick hack to print a …
(edit) @1679   10 months stefanct Fix unlocking function for most Atmel AT2[56]D* chips. I broke unlocking …
(edit) @1678   10 months stefanct sbxxx: spibar[0] debug print refinements. Newer models support a 66 MHz …
(edit) @1677   10 months stefanct Add W25Q...W series. - Use ".V" (and "_V" in macros) for 3.3V Winbond …
(edit) @1675   11 months stefanct Change warning regarding protected ICH regions. There is no good reason …
(edit) @1674   11 months stefanct dediprog: fix SPI clock setting. Avoid setting SPI speed on firmware …
(edit) @1673   12 months stefanct dediprog: add support for chip select. Thanks to the traces captured and …
(edit) @1672   12 months stefanct Update spi_get_erasefn_from_opcode(). We forgot to add a few SPI erase …
(edit) @1671   12 months stefanct Add support for PMC Pm25LD series. This patch adds support for - …
(edit) @1670   12 months stefanct Refine PMC Pm25LV series. - Add missing bits and resort chips - Refine …
(edit) @1669   12 months stefanct Initialize sp_fd and fix baud rate setting on windows. Signed-off-by: …
(edit) @1668   13 months stefanct Get rid of perror(). It prints to stderr and that's not what we want …
(edit) @1667   13 months hailfinger usleep() is not found in all versions of MinGW, use Sleep() on Windows. …
(edit) @1666   13 months stefanct Refine granularity handling in preparation of AT45DB series support. This …
Note: See TracRevisionLog for help on using the revision log.