Changeset 1451 for trunk/flashrom.8

Timestamp:

Oct 14, 2011 10:33:14 PM (20 months ago)

Author:

uwe

Message:

TIAO/DIYGADGET USB Multi-Protocol Adapter (TUMPA) support.

Thanks to TIAO/DIYGADGET for sponsoring a test device!

This is an FTDI FT2232H based device which provides an easily accessible JTAG,
SPI, I2C, serial breakout. The SPI part can be used to flash SPI flash chips
using flashrom.

​http://www.diygadget.com/tiao-usb-multi-protocol-adapter-jtag-spi-i2c-serial.html
​http://www.tiaowiki.com/w/TIAO_USB_Multi_Protocol_Adapter_User%27s_Manual#SPI_Connector_1

There are two SPI connectors (pin headers) on the board: SPI1, which is
connected to the FT2232H's A interface, and SPI2, which is connected to the
chip's B interface. Both can be used to flash SPI chips:

flashrom -p ft2232_spi:type=tumpa,port=A
flashrom -p ft2232_spi:type=tumpa,port=B

The default interface is A, so for SPI1 you can also just write:

flashrom -p ft2232_spi:type=tumpa

I tested all operations on both interfaces, everything works fine.

Signed-off-by: Uwe Hermann <uwe@…>
Acked-by: Stefan Tauner <stefan.tauner@…>

File:

• trunk/flashrom.8 (modified) (2 diffs)

trunk/flashrom.8

@@ -200 +200 @@
 FTDI FT2232H Mini-Module, FTDI FT4232H Mini-Module, openbiosprog-spi, Amontec \
 JTAGkey/JTAGkey-tiny/JTAGkey-2, Dangerous Prototypes Bus Blaster, \
-Olimex ARM-USB-TINY/-H, and Olimex ARM-USB-OCD/-H."
+Olimex ARM-USB-TINY/-H, Olimex ARM-USB-OCD/-H, and TIAO/DIYGADGET USB
+Multi-Protocol Adapter (TUMPA).
 .sp
 .BR "* serprog" " (for flash ROMs attached to a programmer speaking serprog), \
@@ -442 +443 @@
 can be
 .BR 2232H ", " 4232H ", " jtagkey ", " busblaster ", " openmoko ", " \
-arm-usb-tiny ", " arm-usb-tiny-h ", " arm-usb-ocd " or " arm-usb-ocd-h
+arm-usb-tiny ", " arm-usb-tiny-h ", " arm-usb-ocd ", " arm-usb-ocd-h \
+", or " tumpa
 and
 .B interface